Le Maitre Neutron Pro Hazer Problems

[chris325]

Hi everyone,

I'm attempting to fix a Neutron Pro hazer and running into some issues. For some context, I recently replaced the air pump and that seems to be working fine now.

The unit powers on and starts heating up, and when the initial self-clean phase wraps up there's no haze and the 'monitor' LED begins flashing quickly. (The manual says this is bad.) On my first couple of troubleshooting attempts the heating coil did emit some smoke, but it seems to no longer do so. (This is the first time the hazer has been used in quite a while.) Any ideas as to what might be wrong? Thanks in advance.

-Chris

 

[Amiers]

Element sounds clogged. You could run some vinegar through it and then some distilled water.

If it hasn't been used in a while the element might be so clogged that you might have to replace it.

 

[BillESC]

I agree with Amiers assessment.

 

[Cory Gira]

I'm having the same LED indicator behavior and the coil element is not even getting hot. Should I try the same fix, or is the element dead if it stays cold?
Thanks very much.