I apologize if this is in the wrong section, but I felt this would fit better in this section than in the lighting and electrics section.
I am using a Musicians Gear lighting stand to hang my lights which is supposed to have a 1.5" T-bar, but strangely my ADJ 1.5" o clamps were about 1/8" too large. Lo and behold, I measured the T-bar pipe to discover that it was actually 1 3/8" in diameter, not 1.5" like it is supposed to be. What would be the easiest and most secure way of resizing the clamps to fit the bar? They would need to be secure enough to hang my Intimidator Spot 250s and Slimpar64s from the stand. I was thinking about cutting up an old 1/16" thick mousepad and supergluing it to the inside of the clamp, but what worries me is that the mousepad would be too soft to hold a mover securely. Does anyone have any experience with this?
I am using a Musicians Gear lighting stand to hang my lights which is supposed to have a 1.5" T-bar, but strangely my ADJ 1.5" o clamps were about 1/8" too large. Lo and behold, I measured the T-bar pipe to discover that it was actually 1 3/8" in diameter, not 1.5" like it is supposed to be. What would be the easiest and most secure way of resizing the clamps to fit the bar? They would need to be secure enough to hang my Intimidator Spot 250s and Slimpar64s from the stand. I was thinking about cutting up an old 1/16" thick mousepad and supergluing it to the inside of the clamp, but what worries me is that the mousepad would be too soft to hold a mover securely. Does anyone have any experience with this?
Last edited: