Control/Dimming Set up iRFR app with etc element2

[Grant Powicki]

I am trying to set up the iRFR app on a phone and I was wondering how to do the setup. We have an ETC Element 2 and a Netgear N900 Wireless Dual Band Gigabit Router. Can someone provide instructions for the setup?

 

[sk8rsdad]

This applies to the whole EOS console family, including Element.

https://www.etcconnect.com/Support/Articles/aRFR-How-to-Setup-Your-Wireless-Network.aspx

 

[JimmyM]

I followed the guide on our element and it worked perfectly, just make sure you don't skip any steps and do each one. The first time I rushed and it didn't work, but just doing everything it said it worked fine.

On another note, make sure you only have the light board on the network, and make sure all the devices are in the same subnet. if I recall correctly it should be 192.168.0.0 and a subnet mask of 255.255.255.0 the router might try to do 10.0.0.0 for the control device, and the board could be set to 192.168.x.x which i did run into.