deltaleader
Member
Okay, so I am programming cues for South Pacific, and while the board is on and running, all cues playback fine. But then after a night off, I turn it back on and all of the cues have channels correct, but all the channels are at 0%. I tried making a completely new file, new settings and everything, but still the same thing; after a power cycle, no intensity is recorded.
It may or may not be beneficial to note that I recorded the show off of submasters. I would run up the sub I wanted for each area, and then record the cue. What gives? anybody have a solution? Is there anyway to salvage what I had recorded? This would be nice because that would be 4 hours less of re-re-programming.
Thank You!
It may or may not be beneficial to note that I recorded the show off of submasters. I would run up the sub I wanted for each area, and then record the cue. What gives? anybody have a solution? Is there anyway to salvage what I had recorded? This would be nice because that would be 4 hours less of re-re-programming.
Thank You!