Hi everyone, I have a couple noobish dimmer questions. I don't know much about mechanical aspects of dimmers because, I have never needed to worry about them. We have a Leviton/Colortran i98 rack with 48 dimmers. Questions 1, Why are the channels spaced out so much? Not just 1, 2, 3 and so on, but the channel number sheet has 1 through 16 as the foh spotlights, and like, channel, 167 as houselights row 7 etc.? I'm pretty sure each fixture we own only has one channel, intensity. About adding a new fixture. Our dimmers are pre-wired, just need to plug into the fly bars above the stage, and if all dimmers arent pre-wired I would have to..well, I would have to call the person who desighned the theatre about that, because the dimmer is against the wall with no access to the rear of the dimmers. And all wires pipped in through the top. Anyways, Fixtures have not been plugged into different channels, or new fixtures added in..wlel, since the theatre was built I am assuming, will I need to be careful with the specific dimmer or anything? It not being using for so long? Or will it be fine? Because we are planning on getting at least 10 new fixtures soon. How to dimmers really work? For some reason I am getting a picture like, Going from the DMX outlit were I plug the board into, that outlet goes to dimmer 1, out of dimmer one to dimmer 2, and so on to 48, so they are all daisy chained, and a fixture is plugged into any dimmer. But what about a DMX light, like a moving head or a LED effect? What would I do with it? Because we are thinking of one or two DMX lights aswell, but I really dont know what to do with them. I would call in the desighner for somethign like this, but if you guys culd help me, I wouldnt need to bother him. Thanks : ) I dont know much about dimmers because since I got onboard in the schools theatre, it was pretty much set it and forget it, you know?