Just bought six used ColorRanger scrollers with a power supply for $278 including shipping on ebay. I think I got a good buy. They just arrived and to my surprise they threw in one scroller for parts. The gel strings look in good condition.
I searched the forum, found one thread that discussed these scrollers. I have looked on the Morpheus site and downloaded the ColorFader manual.
We are a small community theatre in New Jersey, 110 seats in a converted two room school house. We have an Expression 48/96 with an ETC/LMI 24 circuit 1.2 KW touring rack and 4 Sunn PS 1200. Shortly we will be upgrading to a ETC Sensor 48 rack.
Ok now the questions.
Where is the best place to get the four pin cables I need to connect the scrollers to the power supply?
Or should I make them myself?
If so what kind of cable do I need and where is the best place to buy the cable and connectors?
I have never used scrollers before. I will be using these scrollers with my inventory of old Fresnels and Lekos that we have had donated to us over the years.
Any tips, hints, and advice would be appreciated.
Dominick Abbatiello,
Somerset Valley Players
I searched the forum, found one thread that discussed these scrollers. I have looked on the Morpheus site and downloaded the ColorFader manual.
We are a small community theatre in New Jersey, 110 seats in a converted two room school house. We have an Expression 48/96 with an ETC/LMI 24 circuit 1.2 KW touring rack and 4 Sunn PS 1200. Shortly we will be upgrading to a ETC Sensor 48 rack.
Ok now the questions.
Where is the best place to get the four pin cables I need to connect the scrollers to the power supply?
Or should I make them myself?
If so what kind of cable do I need and where is the best place to buy the cable and connectors?
I have never used scrollers before. I will be using these scrollers with my inventory of old Fresnels and Lekos that we have had donated to us over the years.
Any tips, hints, and advice would be appreciated.
Dominick Abbatiello,
Somerset Valley Players