So I tried the steps on the pdf and even hooked up an unmanaged
network switch. Still no response from the capture software.
Here is my setup, maybe somebody can see something is setup incorrectly.
The
element settings for the
network are as follows:
Status is Online
Obtain IP automatically is disabled
IP
address is 10.101.97.101
Subnet Mask is 255.255.0.0
Default Gateway is 10.101.97.101
sACN is checked for both Local Area Connection and Default (Priority 100, Draft Version v0.2 is selected)
net2 - EDMX is also checked for Local Area Connection and Default (Priority 10)
Output to
Visualizer is checked.
Allowed Output Addresses: From (blank) to (blank) with ADD not highlighted; underneath it reads From 1 to 65536 with REMOVE highlighted in yellow
Interface protocols:
Multiconsole is checked for Local Area Connection set to Standard
Network
Sensor
Feedback is checked
RDM is checked
WiFi remote is unchecked
UDP Strings is checked
DHCP services is enabled
First IP
Address is 10.101.97.101
Number of addresses is 500
Subnet mask is 255.255.0.0
Routed is checked
Default Gateway is 10.101.97.101
Update Service (TFTP) enabled
TIme Service (SNTP) enabled
Mode: Server
ETC Net2 Time is enabled
External Time Server is disabled
My OS version is 2.1.0.9.0.2
Image Provisioning Version is 1.1.0.9.0.25
Welcome
Screen Version is 2.0.1.9.0.7
Laptop is Windows 7
IP
address: 10.101.97.103
Subnet mask: 255.255.0.0
Default Gateway is 10.101.97.101
I have all Firewalls and Security Programs disabled. I have been loading the Capture
Intro Training.exe file and try to patch 1-4 and bring them up to full, but get nothing. When I ping the
console from my laptop, I get a reply of less than 1ms, 4 packets sent and 4 received. When I try to ping the laptop from the
console, it just keeps repeating "Reply from 10.101.97.103 in 0ms TTL=128" so I don't know if this is good or bad.
Again, I thank everyone for their help and patience.