Did you install the FTDI drivers?
It looks like it's a standard "Open DMX" device, so in your software there should be something like that. In freestyler it'd be Enttec Open DMX I believe.
ive got freestyler open, i open the thing where you turn the light on and off.. like 0-255 and i put it to 255 and the light lights up but not very bright? but then if i keep making it go from 0-255 like sliding it it flickers really bright unbright...
if i go onto the show all panels button... and if i put the slider to 100% its not very bright but if i slide it to 22% it goes very bright... which is what i want?
Did you install the FTDI drivers?
It looks like it's a standard "Open DMX" device, so in your software there should be something like that. In freestyler it'd be Enttec Open DMX I believe.
right im in freestyler..
if i go onto the show all panels button... and if i put the slider to 100% its not very bright but if i slide it to 22% it goes very bright... which is what i want?
right im in freestyler..
if i go onto the show all panels button... and if i put the slider to 100% its not very bright but if i slide it to 22% it goes very bright... which is what i want?
Also possible that you have reverse polarity on the cable between the box and the dimmer. Make sure pin 2 ends up at pin 2 and pin 3 ends up on pin 3. If you grabbed a mic cord for the test, it may be flipped. Would still work fine as a mic cord, but DMX would erratic to non-functional. Yes, if you are getting any results, the software found the com4 port.