Be careful in that wish... R&D' doing
LED node for some
Leko's this past Spring. Yep' you can in using a high
power LED node if the idea above. Need serious
heat sink and forced cooling probably which would need cleaning and fan could wear out. In testing the lighting source never reached a temperature it would fail soon, and the lamp/
node would fail - but we were really close to it's maximum after only a few hours without forced cooling. Testing with medium output lamp which would probably be fine for a
house.
On the other
hand, sustained use would no doubt be a bad thing to use. I was R&D on a 8"
Leko cannon with a 12" body so it was in any way a larger free air cooling
fixture body than this shown I think - don't bother R&D doing a
LED node for the light.
Instead perhaps a re-design to fit a MR-16 or
PAR say Soraa type narrow or medium/narrow beam lamp sized to match that snout I think the light is projecting
thru. This would run cooler, have a
reflector and would be using all
UL listed parts all about in wiring and mounting.
John D's observation correct in finding the catalogue? Been all
thru the Kliegl catalogues, but never noted such a thing... than again I'm normally looking for something I'm working on. More photos please in getting a better understanding of what you are working on.
Strange,
stage lighting fixtures are not listed for home use I believe even back than. More photo's as per a nerd, and today I didn't have the energy to go up to the under the organ access hole, four stories up... after other up and down all day long. To remove from the procenium, and replace the down lights which are going
thru such a funnel - slightly larger in 6" seemingly. More photo's all about your project before I go up there again in prep. help.