Hi, im a high school senior and Ive been having trouble with getting my crew's LS9-32 and Yamaha Studio Manager to agree with each other. ive got the ls9 set up with a wireless router so i can control it with a laptop from various places. Before i get into this, i have read the entire "Problems with Yamaha Studio Manager for LS9-32" thread several times and it has helped some but not enough. so if anyone has any additional information, it'd be greatly appreciated.
Ive had this setup working for at least 2 years now, but every now and then (especially when we break down, clean out and set back up), the console and the software have a disagreement. this time, Ive gone through pretty much all of the steps, but im not getting to where i need to be. Ive re downloaded the network driver several times, matched the IP, subnet, mac address and Midi port. Ive pinged the console with command prompt and Ive gotten all 4 pings back, 0% loss. ive gone through all the setups with Studio manager, remapping midi ports, modified workspace, adjusted midi settings and all that jazz. when i launch the ls9 software, i go through and i setup the input/output ports to the ls9. the problem is when i go to sync. i sync from console>pc and i get to about 30% and i get:
"Failure [Parameter out of range error (-1)][26 sec]"
i can control the board and make changes in real time, but when it gets to the scene load portion of the sync, it stops. so everything looks like the default and not how it would appear if it had synced properly.
the past few days have been very frustrating, downloading new drivers, firmwares, software, scouring forums and countless hours of trial and error. Any help with this would be GREATLY APPRECIATED!!
Thanks!
Ive had this setup working for at least 2 years now, but every now and then (especially when we break down, clean out and set back up), the console and the software have a disagreement. this time, Ive gone through pretty much all of the steps, but im not getting to where i need to be. Ive re downloaded the network driver several times, matched the IP, subnet, mac address and Midi port. Ive pinged the console with command prompt and Ive gotten all 4 pings back, 0% loss. ive gone through all the setups with Studio manager, remapping midi ports, modified workspace, adjusted midi settings and all that jazz. when i launch the ls9 software, i go through and i setup the input/output ports to the ls9. the problem is when i go to sync. i sync from console>pc and i get to about 30% and i get:
"Failure [Parameter out of range error (-1)][26 sec]"
i can control the board and make changes in real time, but when it gets to the scene load portion of the sync, it stops. so everything looks like the default and not how it would appear if it had synced properly.
the past few days have been very frustrating, downloading new drivers, firmwares, software, scouring forums and countless hours of trial and error. Any help with this would be GREATLY APPRECIATED!!
Thanks!