SteveMcQueen
Member
Hello everyone
I have tasked myself to repair around 10 elements the are Sennhesier ME2, the ones that come with the G3 bundles. I purchased the new connectors, assuming most of the issues are the connectors and a short somewhere around the connector.
My question is that there are 2 wires in these elements and 3 pins. They have the TRS 2.5mm locking connector. The white wire goes to the tip, and bare wire goes to Ring and Sleeve. My question is that does it really have to go to the Ring. I have a transmitter to test them, on the SK300 I cn see if it receiving signal, but I don't have receiver to hear the single. I'm worried that if I don't connect the Sleeve and Ring, that there will be a hum. IS that true? What is the best way to connect the ring and sleeve if i can't go without the ring. the poles have holes in them. Do I run the sire though one whole and solder to the other?
Steve
I have tasked myself to repair around 10 elements the are Sennhesier ME2, the ones that come with the G3 bundles. I purchased the new connectors, assuming most of the issues are the connectors and a short somewhere around the connector.
My question is that there are 2 wires in these elements and 3 pins. They have the TRS 2.5mm locking connector. The white wire goes to the tip, and bare wire goes to Ring and Sleeve. My question is that does it really have to go to the Ring. I have a transmitter to test them, on the SK300 I cn see if it receiving signal, but I don't have receiver to hear the single. I'm worried that if I don't connect the Sleeve and Ring, that there will be a hum. IS that true? What is the best way to connect the ring and sleeve if i can't go without the ring. the poles have holes in them. Do I run the sire though one whole and solder to the other?
Steve