I might be overlooking something obvious, but I am pressed for time. I am altering a previous show file on a Preset Pallete II, and previous cues using macros run fine, but of course, won't copy into new cues.
I need to GO a second cue list with a macro. The second list essentially flashes all of the lights one time to full and off. When I try to add the macro to a new cue, only one light flashes. The 2nd cue list runs fine in macros that were previously existing in the file.
Any idea where I am going wrong? Is it possible the old file is not compatible with my current os? I think it is on 10.8.2 and was going to upgrade after this show was done.
I need to GO a second cue list with a macro. The second list essentially flashes all of the lights one time to full and off. When I try to add the macro to a new cue, only one light flashes. The 2nd cue list runs fine in macros that were previously existing in the file.
Any idea where I am going wrong? Is it possible the old file is not compatible with my current os? I think it is on 10.8.2 and was going to upgrade after this show was done.
