I just picked up a Yamaha EM-150ii and 2 12" 3-Way passive cabs. When I run a mic or iPod into a channel, the meters on the board indicate so. However, I'm not getting anything out of my speakers. I've tried plugging them to Monitor 1, Monitor 2, Speaker 1 L, Speaker 1 R, Speaker 2 L, Speaker 2 R. I was under the impression that since my Yamaha is a powered mixer (isn't it?), I could get away with not using an amp. I'm positive that the speakers work, as I just tested them with my home theatre receiver. Any thoughts?
I've tested continuity on all of my cables and they're fine. I even went straight from iPod to speaker and it played fine.
Heres a link to my speakers: Podium Pro Audio 12" Pro Audio Speaker by OnlyFactoryDirect
Any my board: http://www.audiobar.net/viewthread.php?tid=270760
Thanks
I've tested continuity on all of my cables and they're fine. I even went straight from iPod to speaker and it played fine.
Heres a link to my speakers: Podium Pro Audio 12" Pro Audio Speaker by OnlyFactoryDirect
Any my board: http://www.audiobar.net/viewthread.php?tid=270760
Thanks