DCATTechie
Active Member
Have an odd one for you guys. I'm not able to send a signal to the monitors independent of the fader and LR BUS.
The only way to get the signal to the monitors is
-To have the channel fader up,
-The channel ON/Un-muted
-Have the channel assigned to the LR
-Selected Signal value to AUX using AUX Send knobs (as usual)
Issues:
- I can't send a signal to just the monitors, everything has to be sent through the house system.
-The AUX Send knobs seem to be dependent of the channel fader. Meaning, if I lower the level of a mic in the house, that level is also dropped in the Monitor Feed.
NOTE:
-Changing the AUX Send from Pre to Post Fade seems to have no effect.
-The signal is coming from a CD player via (2) RCA to XLR cables, each going to it's own channel. The gain is at 0 because the signal is a line feed(correct?)
Thanks!
The only way to get the signal to the monitors is
-To have the channel fader up,
-The channel ON/Un-muted
-Have the channel assigned to the LR
-Selected Signal value to AUX using AUX Send knobs (as usual)
Issues:
- I can't send a signal to just the monitors, everything has to be sent through the house system.
-The AUX Send knobs seem to be dependent of the channel fader. Meaning, if I lower the level of a mic in the house, that level is also dropped in the Monitor Feed.
NOTE:
-Changing the AUX Send from Pre to Post Fade seems to have no effect.
-The signal is coming from a CD player via (2) RCA to XLR cables, each going to it's own channel. The gain is at 0 because the signal is a line feed(correct?)
Thanks!