cesargoose
Member
Can you describe the situation a bit more. Are you saying that the red clip light is on all the time and you can never get signal through or that when the clip light is on you lose signal or is it some other issue?
Ok so this is the story, I bought an Itech-6000 from ebay, with 400 something hours. I did two gigs with it and every thing was fine. Then on the third gig it was failing from channel one. I run my Itech stereo all the time. When I hook up my speakers I don't put them too loud, maybe I use 2000 watts per side(channel) at most. For the speakers I hook up one JBL MRX-528 into each channel. That being said I run on 4ohm stereo, the amplifier is capable of giving us 3000 watts a channel on 4ohms. I know I am not clipping my amp to the point of distortion. On channel one of the amp the music signal will be running through it and playing music, then all of a sudden the amp clips! When it clips the red light is on in (red led light place where it says clip). Then no music signal passes the amp from the channel one. And it is hard to get rid of the clip light, because once it is gone we are back in business. Lately the light will turn on when there is not even a signal present, neither is an xlr cable present at all. As I said clipping only happens on channel (one). Which sucks because I can't take advantage of the whole amplifier because I have it running in stereo and I only use channel two. If I were to bridge the amp I couldn't because that would be resorting to channel one exit signal, and thats useless because the clip light is present.