I recently received several RGB led fixtures from china. The fixtures are IP68 and designed to live underwater (so Im told...) The actual circuit board is completely covered in silicone so there is no getting into the fixture without ruining the seals.
Here's my question, I have about 25 fixtures already pre-assigned DMX addresses 3 apart for each color starting at 1 and going to 75. I'm running a Hog with only 2 available universes which both are currently in use. I'm looking for some sort of solution that will allow me to redirect or reassign a DMX command. For example, I addresses the device whatever, 350 for example and it outputs address 1. So I would need addressing like the following.
Console Output 350 - DMX Output Device Address 1
Console Output 351 - DMX Output Device Address 2
Console Output 353 - DMX Output Device Address 3
Console Output 354 - DMX Output Device Address 4
and on etc...
Does something like this exist or is this even possible? Any help is appreciated, Thanks!
Here's my question, I have about 25 fixtures already pre-assigned DMX addresses 3 apart for each color starting at 1 and going to 75. I'm running a Hog with only 2 available universes which both are currently in use. I'm looking for some sort of solution that will allow me to redirect or reassign a DMX command. For example, I addresses the device whatever, 350 for example and it outputs address 1. So I would need addressing like the following.
Console Output 350 - DMX Output Device Address 1
Console Output 351 - DMX Output Device Address 2
Console Output 353 - DMX Output Device Address 3
Console Output 354 - DMX Output Device Address 4
and on etc...
Does something like this exist or is this even possible? Any help is appreciated, Thanks!