DutchVander
Member
One of my student techs is doing some pro bono lighting work for a local community theatre and has run into an issue no one can seem to figure out.
He added an LED wash light to their grid and then everything stopped working. Even after removing the new LED fixture nothing is functioning. I'm troubleshooting this over the phone so information is somewhat limited.
Console is a Colortran Encore. Hang is 8 LED wash fixtures and a few traditional fixtures run off dimmer packs. Apparently their is some kind of loss of signal somewhere because the board is acting like everything is on but none of the fixtures (LED or traditional) respond. All cables have been checked/swapped and verified as plugged in.
Any Ideas?
He added an LED wash light to their grid and then everything stopped working. Even after removing the new LED fixture nothing is functioning. I'm troubleshooting this over the phone so information is somewhat limited.
Console is a Colortran Encore. Hang is 8 LED wash fixtures and a few traditional fixtures run off dimmer packs. Apparently their is some kind of loss of signal somewhere because the board is acting like everything is on but none of the fixtures (LED or traditional) respond. All cables have been checked/swapped and verified as plugged in.
Any Ideas?