Gooday all,
I have been coming to this site for a while now and it is just a wealth of knowledge and information. I will give you all a proper introduction in the "New Members" section and let you know who I am and what I do. But for now I just have a quick question about Robes and their different modes. More specifically the Robe ColorSpot 575 AT. We have recently purchased a couple of these and are using a Jands Vista I3 as the control desk. Now... I can only get light output from them if I load up the Mode 1 personality for one and Mode 2 for the other. If I try and use say Mode 2, 3, or 4 for fixture A, I cannot get any light output, but tilt pan etc all work fine (and same goes for Mode 1, 3, and 4 for Fixture B). Now my reading around suggests that if you load a personality that is inconsistent with what mode the light is running you will not be able to get any light output. (PS I know the lamp strikes as I can see through the casing, but the shutter will not open even though it is opened on the desk) So basically I would just like a bit more information about the different Modes and how they work and how to change what mode the fixture is running in. I have scoured the manual and the internet and cannot seem to turn up any information on this. Please let me know if you need any more information from me. And hopefully this isn't an incredibly stupid question. Thanks Everyone
I have been coming to this site for a while now and it is just a wealth of knowledge and information. I will give you all a proper introduction in the "New Members" section and let you know who I am and what I do. But for now I just have a quick question about Robes and their different modes. More specifically the Robe ColorSpot 575 AT. We have recently purchased a couple of these and are using a Jands Vista I3 as the control desk. Now... I can only get light output from them if I load up the Mode 1 personality for one and Mode 2 for the other. If I try and use say Mode 2, 3, or 4 for fixture A, I cannot get any light output, but tilt pan etc all work fine (and same goes for Mode 1, 3, and 4 for Fixture B). Now my reading around suggests that if you load a personality that is inconsistent with what mode the light is running you will not be able to get any light output. (PS I know the lamp strikes as I can see through the casing, but the shutter will not open even though it is opened on the desk) So basically I would just like a bit more information about the different Modes and how they work and how to change what mode the fixture is running in. I have scoured the manual and the internet and cannot seem to turn up any information on this. Please let me know if you need any more information from me. And hopefully this isn't an incredibly stupid question. Thanks Everyone