tyler.martin
Active Member
I've got a Apollo SmartColor 7.25 that seems to get confused when it is given a command from the console. Basically it won't home to the correct location, and on the Ion I have our scrolls built and calibrated, but if I tell it to go to Frame 4 it will go quite a bit further. If I try to use the encoder wheel to set the level, it will only go as far as frame 2 or 3. There is a return line on the run, there are only 2 scrollers on a 750w PSU, there is another SmartColor on the line that works fine. The one in question is addressed correctly, not overlapped, patched as a generic scroller (but i tried the real profile) not proportioned on the board...
I figure it is an issue with the DMX board on the unit itself. Any other ideas?
I figure it is an issue with the DMX board on the unit itself. Any other ideas?