Didn't I already
send out a bunch of
gel frames and lamps a few months ago? Must have been to someone else.
I'll check
stock at work tomorrow, Believe I still have a few stacks of each.
I also have lots of various other parts especially 360/
360Q stuff. PM me with what you are looking for.
Check your lamps & lamp bases for arching. Might find a swivel automotive repair swivel mirror on a stick and a flash light is the best way of inspecting.
RSC cyc lights are notorious for lamp sockets going bad & taking the lamp with it, than destroying all future lamps like a virus. A Dremmel tool with silicone abrasive fiber wheel should be able to clean them. Spray some Sprayon EL2001 or coat fresh brite work of bases with high temp. deoxident - it will help preserve their life. If the lamp bases are not salvageable, I probably have lots of lamp bases and reflectors about also. Open the fixtures up and inspect the wiring.
On
gel, depends on the saturation.
Colortran cycs run cooler than
Altman Cyc's though, also given its a two lite instead of a six lite it's not going to get anywhere near as warm.