For larger stuff, no, but they cut
throw 12g stranded cable just fine.
Will cut
thru a 12ga stranded
wire (not persay cable) but it would also wear on the pivot
point of the
scissors. The
scissors are great and cut from a
gobo to kevlar without a problem when sharp but not magical and if you find a need to use the entire
hand as opposed to two fingers to cut something you are probably abusing if not the blade, that pivot
point which will wear and potentially loosen up at the joint even more so than the blade.
Once dull they most likely are not worth sharpening, get a new pair for like $14.00. Really good price and valuable
scissors for any number of materials. They don't cut hair or fabric so well - different blade angle which is important in why they work better for most work but not perfect for all stuff. You will note that a Swiss Army Knife will seemingly cut paper better than electricians
scissors - that is attributed to the blade angle, though electricians
scissors will cut paper fine for the most part.
One big thing no matter the brand is a problem with that pivot. Normally it is a screw that should be able to tighten some but normally it does not nor should it unless you wish to constantly have to tighten it. At times the screw itself or the hole it fits into does not properly fit and there is some
play between blades. One of my assistant's
scissors is like that, kind of have to squeeze/twist the blades together as you cut type of thing like with child like
safety scissors. Drives me up a wall. I will have returned them - and most brands of electricians
scissors have a full warranty on them. If they were tight but loosen up over time
return them or an anvil pin punch and mini sledge hammer should allieviate that
play. Tightening the screw does not work so well - see above but could dependant upon the brand. If you find the
scissors binding and sticking a
bit, clean them with a adhesive remover such as Goof Off or Goo Gone, if not oil them with WD-40 which will also to some extent remove goo as with lubricate them. Should solve the problem unless dings in the blade. If dings in the blade, a file on the
flat side filing the ding
flat again should solve the problem without attempting to resharpen. Fairly rare you will ding or kink your blade given the angle of it somewhere between that of fabric or hair
scissors and paper
scissors but possible especially if you try to cut say 1/16"
wire rope that is also theoetically possible but not proper. Sure as with 12ga cable you could but it would be wrong and potentially do damage to the tool especially at its pivot.
The cut angle and strength of the
scissors is the main selling
point. There is a high leverage version also available - same basic thing just with multi-finger handles. Yet to try them, see rule one about able to cut but getting too ambitious about what you cut. A good pair of diagional side cutting pliers for cutting
wire amongst other types of
wire cutters would be easier and proper. There is no all
in one tool. Proper tool for the proper job. Me being a Klien person for most tools like the
scissors with the
wire stripper slots on them - yet to use the stripper slot for other than telecom but they just traditionally just seem to hold up better than the ones without even if the same in my impression.
For side cutting pliers, a good Journeymen D2000-48 that are hardened steel, 15 degree beveled
edge will last you years longer than any other brand or type. Well worth the about $25.00 investment. Once dull you cannot resharpen sufficiently this tool so buy something that is sharp and properly aligned to start with and will stay sharp for years no mater what you are cutting with them. Again seeing concepts about cutting what designed for. In this case
wire, screws and steel plate without a problem is fine. Handle type as similar to a few more modern style of handle out there also holds up better than the old vinyl coated handles.