Morte615
Active Member
I can't get to my manuals till tomorrow afternoon, which is when I need to start this project, so I am going to ask the hive mind. Is there a way to set up an ETC EOS RPU to start back up after a power outage. The system is already installed but being renovated to run nightly without an operator. So I am just worried that if we lose power, or someone hits the wrong switch, that the system will not run because the EOS was never turned back on!
I already know how to setup the computer that will be operating the cues (with SFX) to turn on when power is received, so the EOS is the main issue right now.
I already know how to setup the computer that will be operating the cues (with SFX) to turn on when power is received, so the EOS is the main issue right now.